getting a lot of curling on edges? TTYD3D silk pla, bed temp 50/50 (and tried lower). first layer looks good : r/prusa3d
OzFDM Silk PLA 3D Printing Filament 1.75mm 1KG
Using silk PLA at 215/65 temps. I cannot seem to get this to print. Cursed Eevee print. Used different filament (also silk PLA). Leveled bed with paper many times. Adjusted z offset.
eSUN eSilk-PLA 1.75mm 3D Filament 1KG – eSUN Offical Store
Anyone else having issues getting TTYT3D Silk PLA to stick? Tried clean pei bed (99.9% IPA), glue stick, textured pei, MagiGoo, GeckoTek, temp changes on bed and filament, this stuff still peels